Knowledge Base
Knowledge BaseSubject: | Pin Position |
---|---|
Status |
Resolved |
Product | WireCAD v9 |
Product Level | PRO |
Database Type | VISTADB |
Build Number (last 4 digits of version) |
Message
Hello,
is there a possibility to change a pin position on body of equipment.
For example, I have made a block for a frame which has only one pin for connecting to network switch.
To make it larger than usual I have use Vertical padding option and set it to 1750. Now I would like that my pin is not in the middle of body, but just a little bit above lower margin of body.
Is it possible?
Best regards,
Marijan
is there a possibility to change a pin position on body of equipment.
For example, I have made a block for a frame which has only one pin for connecting to network switch.
To make it larger than usual I have use Vertical padding option and set it to 1750. Now I would like that my pin is not in the middle of body, but just a little bit above lower margin of body.
Is it possible?
Best regards,
Marijan
13-March-2018 (10:40 AM)
Unfortunately, with an singular output, the default in the current system is such that the output will automatically appear centered on the reflected block.
Thanks,
McKensee
Thanks,
McKensee
14-March-2018 (06:57 PM)